Search
Close this search box.

Linear motor MG-166

LINEAR MOTOR ACTUATORS

TECHNICAL DESCRIPTION:

These devices are, in fact, electric servomotors, intended for linear direct drive of machine elements and technological lines, where high speeds of movement, dynamics, precision and frequent or dynamic reconfiguration of the movement trajectory (on-line) are required. In such situations, the linear motor is an excellent alternative to pneumatic actuators or electric drives with ball screw or drive belt. The motor is characterized by high reliability and low wear during operation. It does not require special lubrication or seals and the involvement of maintenance services is much lower compared to other types of linear drive. No need to connect compressed air makes it much easier to maintain the cleanliness regime in cleanrooms.

The motor consists of two main elements: a forcer with windings, electrical connections, a position sensor and a sliding shaft filled with permanent magnets, which works concentrically with the forcer. The working load can be attached to the moving shaft (the forcer is permanently attached to the machine) or to the forcer (the shaft is stationary and the forcer moves).

A non-contact linear encoder is built in the motor, which provides a feedback signal for control systems in the sin/cos 1Vpp standard and thermal overheating protection.

To supply and control the motor, a properly configured servo amplifier is required, which accepts the feedback signal and ensures that the parameters required by the motor are achieved. The servo amplifier can come from any manufacturer, as long as it meets the requirements of the motor.

EXAMPLE APPLICATIONS:

  • packaging machines,
  • dosing machines,
  • pick & place systems,
  • automatic assembly,
  • feeders and manipulators,

PARAMETERS:

  • maximum continuous force: 15,8 N (higher when cooled)
  • peak force: 142 N
  • maximum movement velocity: 6,0 m/s
  • maximum acceleration: 200 m/s2
  • positioning accuracy: ±350 μm
  • positioning repeatability: 20 μm
  • shaft diameter: 16 mm
  • working length: from 35 mm
  • shaft length: from 205 mm
  • operational temperature: -20°C … +40°C

 

Information sheet attached.

If the presented product is close to your requirements, but does not quite meet them – please contact us. Today most of our products are created in cooperation with our clients.